| T O P I C R E V I E W |
| ussnowbird |
Posted - 12/14/2015 : 23:50:54
I am having problems when importing pictures with the Wizard not showing all commands at the bottom. I have opened and closed it several times and sometimes it will fix it.
Usually I only get about half the command bar showing. Is anyone else experiencing this and know a workaround?
Any help is much appreciated.
Ussnowbird |
| 1 L A T E S T R E P L I E S (Newest First) |
| Dragonlair |
Posted - 12/15/2015 : 07:38:23
Just as a guess, it may be caused by resolution issues. Do you by any chance use a font size larger than 100%? It should not be an issue but might be. You might try right-clicking on either the shortcut or the main executable for the product and clicking on Properties. Under the Compatibility Tab, you should see an option for ignoring high DPI scaling. Where the option is on that tab varies depending on your operating system but it is usually near the bottom.
If this is not the case, try adjusting the resolution of the screen (temporarily, you can set it back).
If all else fails, contact Mark on the issue. Just find his profile on this board and send him an email.
Good Luck,
Diane
There is no such thing as a stupid question
|
|
|
