| T O P I C R E V I E W |
| kjl |
Posted - 10/24/2026 : 17:34:32 I want to render my original designs as solid blocks of color instead of symbols, and want the blocks to show as the floss colors I select. How do I do this? kjl |
| 5 L A T E S T R E P L I E S (Newest First) |
| kjl |
Posted - 10/27/2026 : 14:27:46 Thank you! I'm getting colors now (I set the display to symbol and block). I have not yet tried printing a design, but I see in the print options that I can have the stitches show as solid blocks.
I had a hunch it was something obvious, and I was right on that. kjl |
| Dragonlair |
Posted - 10/26/2026 : 17:52:32 When you select a color from "Available Colors", be sure to click on "Add" (at the bottom). That should put it in the bottom panel with a pre-set symbol. That symbol is what you would see if you were requesting the symbol to show on any stitches added. You still see that symbol on the color palette but NOT on the actual design field if you have the setting to "Color Block".
I've checked it. I usually use Symbol and Color Block for each of my stitches and I see the color block with either a black or white symbol (depending on what shows up better). If I change the display to Color Block, those symbols go away and I just see the colors.
If you are not seeing the color in the color palette, something is wrong.
What operating system are you using? Have you modified your system in any way? Have you tried uninstalling the software, rebooting, and then re-installing the software? What troubleshooting steps have you tried?
If all else fails, you can email Mark at mmiller@pcstitch.com . Mark is the only one who can fix actual problems. I can just help get the program to work as you need within the scope of the actual software.
Diane There is no such thing as a stupid question
|
| kjl |
Posted - 10/26/2026 : 16:06:36 Also, if I select in the symbols menu to have symbol color be the same as floss color, my solid blocks are still black. kjl |
| kjl |
Posted - 10/26/2026 : 16:00:08 When I select "solid blacks" and then select a color from "available colors," and then start charting, the blocks are shown in black. How do I make them show as the selected colors? Actually seeing the colors as I develop a chart is crucial to designing. kjl |
| Dragonlair |
Posted - 10/24/2026 : 20:11:12 Under "Home", there's an option to "Display Stitches As" and one of the options (the first one, actually) is "Solid Blocks".
When printing, there is an option (to the left) to print stitches as solid blocks.
Diane There is no such thing as a stupid question
|